I bought the SVO hood pins from Steeda.

Install is fairly easy if you don't mind working on your own car.

What I did:

unscrew the factory hood adjusters to the left and right of radiator.

I found a few long screws in my junk boxes that fit the thread pattern of the hood adjusters and sharpened points in the top with my dremel.

Screw these in and lower the hood softly and apply some pressure over these screws. Not enough pressure so that they break through the fiberglass but enough to mark the underside of the hood.

Remove those screws and the plastic mounting tabs and drill the holes out so that the hood pins will fit in and secure the hood pins from above and below the radiator core support.

Put masking tape on the hood where you will be drilling to help prevent paint chips. Mine chipped a little but the chips are covered by the mounting plate on the top of the hood. Drill small 1/8 - 1/4 inch holes straight through the hood where the mark was made and lower the hood to rest on top of them. Shine a flashlight from the top of the hood and make sure you see the tips of the hood pins.

If you do not see the tips of the pins, make the adjustments needed so that you do. Then drill the holes out to the diameter of the mounting plate holes. On this stage if you have a 2 layer fiberglass hood, drill the top from the top and the bottom hole from the bottom. And do not forget the masking tape.

Drill small holes and screw the mounting plates on to the top of the hood, but not so hard that you tear the fiberglass. You only need enough tension to hold the plate to the hood.

Close the hood and install the pins. The post that sticks out of the hood should be set so that there is very light pressure between the pin and the surface of the hood.

   
New pix with the hood pins
Hood pins and cables
Hood pins and cables
Hood pins and cables
Hood pins and cables
Without cables
Without cables
With cables attached
Without cables
Pin and top plate
Underside of hood
Lower pin plates
Where they will go if I ever install them
Pins in the radiator support
Pins in the radiator support